ACE25C800G datasheet(21/37 Pages) ACE

21 / 37 page

ACE25C800G

Uniform SECTOR Dual and Quad Serial Flash

VER 1.6

Figure 16. 32KB Block Erase Sequence Diagram

64KB Block Erase (BE) (D8H)

The 64KB Block Erase (BE) command is for erasing the all data of the chosen block. A Write Enable

(WREN) command must previously have been executed to set the Write Enable Latch (WEL) bit. The

64KB Block Erase (BE) command is entered by driving CS# low, followed by the command code, and

three address bytes on SI. Any address inside the block is a valid address for the 64KB Block Erase

(BE) command. CS# must be driven low for the entire duration of the sequence.

The 64KB Block Erase command sequence: CS# goes low sending 64KB Block Erase command

3-byte address on SI CS# goes high. The command sequence is shown in Figure17. CS# must be

driven high after the eighth bit of the last address byte has been latched in; otherwise the 64KB Block

Erase (BE) command is not executed. As soon as CS# is driven high, the self-timed Block Erase

cycle (whose duration is tBE) is initiated. While the Block Erase cycle is in progress, the Status

(WIP) bit is 1 during the self-timed Block Erase cycle, and is 0 when it is completed. At some

unspecified time before the cycle is completed, the Write Enable Latch (WEL) bit is reset. A 64KB

Block Erase (BE) command applied to a block which is protected by the Block Protect (SEC, TB, BP2,

BP1, BP0) bits (see Table1.0&1.1) is not executed.

Figure17. 64KB Block Erase Sequence Diagram

ACE25C800G Datenblatt(PDF) 21 Page - ACE Technology Co., LTD.