USB3813 datasheet(40/57 Pages) MICROCHIP

40 / 57 page

USB 2.0 Hi-Speed 3-Port Hub Controller Optimized for Portable Applications

Datasheet

DS00001715A-page 40

 2014 Microchip Technology Inc.

8.2

Flex Connect

This feature allows the upstream port to be swapped with downstream physical port 1. Only

downstream port 1 can be swapped physically. Using port remapping, any logical port (number

assignment) can be swapped with the upstream port (non-physical).

Flex Connect is enabled/disabled via two control bits in the Connect Configuration Register. The

FLEXCONNECT configuration bit switches the port, and EN_FLEX_MODE enables the mode.

8.2.1

Port Control

Once EN_FLEX_MODE bit is set, the functions of certain pins change, as outlined below.

If EN_FLEX_MODE is set and FLEXCONNECT is not set:

1. SUSPEND outputs ‘0’ to keep any upstream power controller off

If EN_FLEX_MODE is set and FLEXCONNECT is set:

1. The normal upstream VBUS pin becomes a don’t care

2. SUSPEND becomes PRTPWR1/OCS1_N for the port power controller for the connector port

8.3

Resets

The device has the following chip level reset sources:



Power-On Reset (POR)



External Chip Reset (RESET_N)



USB Bus Reset

8.3.1

Power-On Reset (POR)

A power-on reset occurs whenever power is initially supplied to the device, or if power is removed and

reapplied to the device. A timer within the device will assert the internal reset per the specifications

listed in Section 9.5.1, "Power-On Configuration Strap Valid Timing," on page 49.

8.3.2

External Chip Reset (RESET_N)

A valid hardware reset is defined as assertion of RESET_N, after all power supplies are within

operating range, per the specifications in Section 9.5.2, "Reset and Configuration Strap Timing," on

page 50. While reset is asserted, the device (and its associated external circuitry) enters Standby Mode

and consumes minimal current.

Assertion of RESET_N causes the following:

1. The PHY is disabled and the differential pairs will be in a high-impedance state.

2. All transactions immediately terminate; no states are saved.

3. All internal registers return to the default state.

4. The external crystal oscillator is halted.

5. The PLL is halted.

6. The HSIC Strobe and Data pins are driven low.

USB3813 Datenblatt(PDF) 40 Page - Microchip Technology

USB3813 Datenblatt(HTML) 40 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57

Datenblatt Download

Link URL