COP8SA datasheet(22/60 Pages) NSC

22 / 60 page

7.0 Timers (Continued)

7.2.3 Mode 3. Input Capture Mode

The device can precisely measure external frequencies or

time external events by placing the timer block, T1, in the in-

put capture mode. In this mode, the reload registers serve as

independent capture registers, capturing the contents of the

timer when an external event occurs (transition on the timer

input pin). The capture registers can be read while maintain-

ing count, a feature that lets the user measure elapsed time

and time between events. By saving the timer value when

the external event occurs, the time of the external event is

recorded. Most microcontrollers have a latency time be-

cause they cannot determine the timer value when the exter-

nal event occurs. The capture register eliminates the latency

time, thereby allowing the applications program to retrieve

the timer value stored in the capture register.

In this mode, the timer T1 is constantly running at the fixed t

rate. The two registers, R1A and R1B, act as capture regis-

ters. Each register acts in conjunction with a pin. The register

R1A acts in conjunction with the T1A pin and the register

R1B acts in conjunction with the T1B pin.

The timer value gets copied over into the register when a

trigger event occurs on its corresponding pin. Control bits,

T1C3, T1C2 and T1C1, allow the trigger events to be speci-

fied either as a positive or a negative edge. The trigger con-

dition for each input pin can be specified independently.

The trigger conditions can also be programmed to generate

interrupts. The occurrence of the specified trigger condition

on the T1A and T1B pins will be respectively latched into the

pending flags, T1PNDA and T1PNDB. The control flag

T1ENA allows the interrupt on T1A to be either enabled or

disabled. Setting the T1ENA flag enables interrupts to be

generated when the selected trigger condition occurs on the

T1A pin. Similarly, the flag T1ENB controls the interrupts

from the T1B pin.

Underflows from the timer can also be programmed to gen-

erate interrupts. Underflows are latched into the timer T1C0

pending flag (the T1C0 control bit serves as the timer under-

flow interrupt pending flag in the Input Capture mode). Con-

sequently, the T1C0 control bit should be reset when enter-

ing the Input Capture mode. The timer underflow interrupt is

enabled with the T1ENA control flag. When a T1A interrupt

occurs in the Input Capture mode, the user must check both

the T1PNDA and T1C0 pending flags in order to determine

whether a T1A input capture or a timer underflow (or both)

caused the interrupt.

Figure 17 shows a block diagram of the timer in Input Cap-

ture mode.

DS012838-24

FIGURE 17. Timer in Input Capture Mode

COP8SA Datenblatt(PDF) 22 Page - National Semiconductor (TI)

COP8SA Datenblatt(HTML) 22 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Datenblatt Download

Link URL