CS8411 datasheet(8/38 Pages) CIRRUS

8 / 38 page

CS8411 CS8412

DS61F1

CS8411 DESCRIPTION

The CS8411 is more flexible than the CS8412 but

requires a microcontroller or DSP to load internal

registers. The CS8412 does not have internal regis-

ters so it may be used in a stand-alone mode where

no microprocessor or DSP is available.

The CS8411 accepts data from a transmission line

coded according to the digital audio interface stan-

dards. The I.C. recovers clock and data, and sepa-

rates the audio data from control information. The

audio data is output through a configurable serial

port and the control information is stored in internal

dual-port RAM. Extensive error reporting is avail-

able via internal registers with the option of repeat-

ing the last sample when an error occurs. A block

diagram of the CS8411 is shown in Figure 4.

Parallel Port

The parallel port accesses two status registers, two

interrupt enable registers, two control registers, and

28 bytes of dual-port buffer memory. The status

registers and interrupt enable registers occupy the

same address space. A bit in control register 1 se-

lects the two registers, either status or interrupt en-

able, that occupy addresses 0 and 1 in the memory

map. The address bus and the RD/WR line should

be valid when CS goes low. If RD/WR is low, the

value on the data bus will be written into the buffer

memory at the specified address. If RD/WR is high,

the value in the buffer memory, at the specified ad-

dress, is placed on the data bus. Detailed timing for

the parallel port can be found in the Switching

Characteristics - Parallel Port table.

The memory space on the CS8411 is allocated as

shown in Figure 5. There are three defined buffer

modes selectable by two bits in control register 1.

Further information on the buffer modes can be

found in the Control Registers section.

Status and IEnable Registers

The status and interrupt enable registers occupy the

same address space. The IER/SR bit in control reg-

ister 1 selects whether the status registers (IER/SR

= 0) or the IEnable registers (IER/SR = 1) occupy

addresses 0 and 1. Upon power-up, the control and

IEnable registers contain all zeros; therefore, the

- 5

- 10

- 15

- 20

- 25

- 30

Jitter Frequency (Hz)

Figure 3. Jitter Attenuator Characteristics

CS8411 Datenblatt(PDF) 8 Page - Cirrus Logic

CS8411 Datenblatt(HTML) 8 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

Datenblatt Download

Link URL