XT40.241, XT40.242

– X-Series

Jan. 2007 / Rev. 1.0 DS-XT40.24x-EN All parameters are specified at 24V 40A, 3x400Vac (XT40.241) or 3x480Vac (XT40.242),

25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

10/20

14. EMC

The power supply is suitable for applications in industrial environments as well as in residential, commercial and light

industry environments without any restrictions. The CE mark is in conformance with EMC guideline 89/336/EEC and

93/68/EEC and the low-voltage directive (LVD) 73/23/EWG. A detailed EMC report is available on request.

EMC Immunity

EN 61000-6-1 and EN 61000-6-2

Generic standards

Electrostatic discharge

EN 61000-4-2

Contact discharge

Air discharge

8kV

15kV

Criterion A

Criterion A

Electromagnetic RF field

EN 61000-4-3

80MHz-1GHz

10V/m

Criterion A

Fast transients (Burst)

EN 61000-4-4

Input lines

Output lines

4kV

2kV

Criterion A

Criterion A

Surge voltage on input

EN 61000-4-5

L1

L2, L2

L3, L1

L3

L1 / L2 / L3

PE

2kV

4kV

Criterion A

Criterion A

Surge voltage on output

EN 61000-4-5

+

-

+ / -

PE

500V

500V

Criterion A

Criterion A

Conducted disturbance

EN 61000-4-6

0.15-80MHz

10V

Criterion A

Mains voltage dips

EN 61000-4-11

0% of 400Vac

40% of 400Vac

70% of 100Vac

0% of 480Vac

40% of 480Vac

70% of 480Vac

20ms

200ms

500ms

20ms

200ms

500ms

Criterion B

Criterion C

Criterion C

Criterion B

Criterion C

Criterion C

Powerful transients

VDE 0160

over entire load range

1300V, 1.3ms

Criterion D

Criteria:

B: During the mains voltage dip, the output voltage will decrease according to curves in the section “Hold-up Time”. The unit works in normal mode

once the voltage dip is over. If criteria A is required, use one or two buffer modules UF20.241 in addition to the XT40 power supply.

C: Temporary loss of function is possible. Power supply might shut-down and restarts by itself. No damages or hazards for the power supply will occur.

D: The input transient blocker opens and the main converter is without input power during such transients. The output voltage decreases similar as

described in the hold-up time section during such an event.

EMC Emission

EN 61000-6-3 and EN 61000-6-4

Generic standards

Conducted emission

EN 55011, EN 55022, FCC Part 15, CISPR 11, CISPR 22

Class B, input lines

EN 55022

Class B, output lines

Radiated emission

EN 55011, EN 55022

Class B

Harmonic input current

EN 61000-3-2

Fulfilled, active PFC

Voltage fluctuations, flicker

EN 61000-3-3

Fulfilled

This device complies with FCC Part 15 rules.

Operation is subjected to the following two conditions: (1) this device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause undesired operation.

Switching Frequency

Switching frequency

36kHz

nearly constant