XT40.241, XT40.242

– X-Series

Jan. 2007 / Rev. 1.0 DS-XT40.24x-EN All parameters are specified at 24V 40A, 3x400Vac (XT40.241) or 3x480Vac (XT40.242),

25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

5/20

Output voltage

nom.

24.1V

Output voltage adjustment range

none

The output voltage is fixed. No adjustment possible

Output current

nom.

40A

50A

Short-circuit current

typ.

180A

Note: The short-circuit current is available for 0.1s

Output power

nom.

960W

continuous

1200W

up to 15s

Line regulation

max.

±2%

Load regulation

max.

800mV

static value, 0A

40A

0A

max.

200mV

static value, 5A

40A

5A

Ripple and noise voltage *)

max.

1500mVpp

20Hz-2kHz, 50Ohm

max.

50mVpp

2kHz to 20MHz, 50Ohm

Output capacitance

typ.

20 000µF

*) The ripple and noise voltage mostly consist of a mains ripple with 300Hz (50Hz mains) or 360Hz (60Hz mains). The ripple and

noise voltage can be reduced by the utilization of external capacitors.

The power supply is also designed to support loads with a higher short-term current and power requirement. The

short-term duration is firmware controlled by an output power manager. If the nominal output power is exceeded for

a certain period of time which is defined in the zone A, B and C, the power supply responds with an automatic shut-

down. Pressing the reset button or cycling the input power (10s off time is required) initiates an attempt to restart. If

the fault has been cleared the device will operate normally.

The short term power can be used periodically. See chapter 26.1 for further information.

Fig. 7-1 Output voltage vs. output current, typ.

40A 50A

140A

80A

0

A

15s

24V

200A

60A

20A

100A

120A

160A

180A

12V

B

5s

C

0.1s

3x 340V

3x 408V

3x 400V

3x 480V

3x 460V

3x 552V

XT40.241 XT40.242

Zone A: 25% extra output power for typ. 15s

Zone B: 100% higher output current for typ. 5s

Zone C: Quick-acting shut-down after typ. 0.1s