CD10.241

CD-Series

DC/DC Converter 24V/24V, 10A, 240W

Input

Output

Type

screw terminals

screw terminals

Solid wire

Stranded wire

American Wire Gauge

20-10 AWG

20-10 AWG

Max. wire diameter

2.8mm (including ferrules)

2.8mm (including ferrules)

Wire stripping length

7mm / 0.275inch

7mm / 0.275inch

Screwdriver

3.5mm slotted or

Pozidrive No 2

3.5mm slotted or

Pozidrive No 2

Recommended tightening torque

1Nm, 9lb.in

1Nm, 9lb.in

Instructions:

a) Use appropriate copper cables that are designed for an operating temperature of:

60°C for ambient up to 45°C and

75°C for ambient up to 60°C and

90°C for ambient up to 70°C minimum.

b) Follow national installation codes and installation regulations!

c) Ensure that all strands of a stranded wire enter the terminal connection!

d) Screws of unused terminal compartments should be securely tightened.

Daisy chaining of outputs:

Daisy chaining (jumping from one DC/DC-converter output to the next) is allowed as long as the average output

current through one terminal pin does not exceed 25A. If the current is higher, use a separate distribution terminal

block.

Fig. 10-1 Daisy chaining of outputs

Fig. 10-2 Using distribution terminals

DC/DC

Converter

+ +

- -

Input

Output

Load

+

-

max 25A!

DC/DC

Converter

+ +

- -

Input

Output

Load

+

-

Distribution

Terminals

DC/DC

Converter

+ +

- -

Input

Output

DC/DC

Converter

+ +

- -

Input

Output

Jul. 2017 / Rev. 1.1 DS-CD10.241-EN

All parameters are typical values at 24V, 10A, 24Vdc input voltage, 25°C ambient and

after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

10/25