CD10.241

CD-Series

DC/DC Converter 24V/24V, 10A, 240W

Output protection

Electronically protected against overload, no-load and short-circuits.

In case of a protection event, audible noise may occur.

Output over-voltage protection

typ. 31Vdc

max. 32.5Vdc

In case of an internal power supply defect, a redundant

circuit limits the maximum output voltage. The output

shuts down and automatically attempts to restart.

Reverse input polarity protection Included

Unit does not start when input voltage is reversed

Output over-current protection

Electronically limited

See Fig. 5-1

Degree of protection

IP 20

According to EN/IEC 60529

Penetration protection

> 3.5mm

E.g. screws, small parts

Over-temperature protection

no

-

Input transient protection

MOV

(Metal Oxide Varistor)

For protection values see chapter 13 (EMC)

Internal input fuse

Included

Not user replaceable slow-blow high-braking capacity

fuse

Classification of output voltage

According to IEC/EN 60950-1

According to IEC/EN 60204-1, IEC 62477-1, IEC 60364-4-

41

Class of protection

III

PE (Protective Earth) connection not required.

A connection of the “Chassis Ground” pin to earth is

recommended for best EMI performance.

Isolation resistance

> 500MOhm

Input to output, 500Vdc

PE resistance

< 0.1Ohm

Between housing and Chassis Ground terminal

Touch current (leakage current)

The leakage current, which is produced by the DC/DC converter itself, depends on

the input voltage ripple and need to be investigated in the final application.

For a smooth DC input voltage, the produced leakage current is less than 100μA.

1)

Provided, that the input voltage meets the requirements of chapter 2.

Jul. 2017 / Rev. 1.1 DS-CD10.241-EN

All parameters are typical values at 24V, 10A, 24Vdc input voltage, 25°C ambient and

after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

14/25