WM8150

Production Data

w

PD Rev 3.0 November 2002

14

CONTROLINTERFACE

The internal control registers are programmable via the serial digital control interface. The register

contents can be read back via the serial interface on pin OP[3]/SDO.

It is recommended that a software reset is carried out after the power-up sequence, before writing to

any other register. This ensures that all registers are set to their default values (as shown in Table

4).

SERIALINTERFACE: REGISTER WRITE

Figure 12 shows register writing in serial mode. Three pins, SCK, SDI and SEN are used. A six-bit

address (a5, 0, a3, a2, a1, a0) is clocked in through SDI, MSB first, followed by an eight-bit data

word (b7, b6, b5, b4, b3, b2, b1, b0), also MSB first. Each bit is latched on the rising edge of SCK.

When the data has been shifted into the device, a pulse is applied to SEN to transfer the data to the

appropriate internal register. Note all valid registers have address bit a4 equal to 0 in write mode.

SCK

SEN

SDI

a5

0

a3

a2a1a0b7

b6b5b4b3

b2b1b0

Address

Data Word

Figure 12 Serial Interface Register Write

A software reset is carried out by writing to Address “000100” withany value of data, (i.e. Data Word

= XXXXXXXX.

SERIALINTERFACE: REGISTER READ-BACK

Figure 13 shows register read-back in serial mode. Read-back is initiated by writing to the serial bus

as described above but withaddress bit a4 set to 1, followed by an 8-bit dummy data word. Writing

address (a5, 1, a3, a2, a1, a0) will cause the contents (d7, d6, d5, d4, d3, d2, d1, d0) of

corresponding register (a5, 0, a3, a2, a1, a0) to be output MSB first on pin SDO (on the falling edge

of SCK). Note that pin SDO is shared with an output pin, OP[3], so no data can be read when reading

from a register. The next word may be read in to SDI while the previous word is still being output on

SDO.

SCK

SEN

SDI

a5

1

a3 a2 a1 a0

x

x

xxx

xxx

Address

Data Word

d7 d6 d5 d4 d3 d2 d1 d0

Output Data Word

SDO

Figure 13 Serial Interface Register Read-back

TIMING REQUIREMENTS

To use this device a master clock (MCLK) of up to 16MHz and a per-pixel synchronisation clock

(VSMP) of up to 8MHz are required. These clocks drive a timing control block, which produces

internal signals to control the sampling of the video signal. MCLK to VSMP ratios and maximum

sample rates for the various modes are shown in Table 3.