Sensor Programming

Programming Procedures: Two push buttons, Dynamic (+) and Static (-), may be used to access and set programming

parameters. For remote programming, connect a switch or digital input to the gray wire; length of the individual pulses is

equal to the value T: 0.04 seconds ≤ T ≤ 0.8 seconds

Returning to RUN mode: TEACH and SETUP modes each may be exited in one of two ways: by exercising the 60-second

time-out, or by cancelling out of the process. In TEACH mode, the sensor will return to RUN mode without saving any of

the new settings; in SETUP mode, the sensor will return to RUN mode but save all of the settings. To cancel out of TEACH

mode, press and hold the Static (-) button for 2 seconds; to cancel out of SETUP mode, press and hold both the Static (-)

and Dynamic (+) buttons for 2 seconds.

Output 2: The setpoint(s) for each output can be set independently of one another (see Super-High Speed Operation).

However, the functional range available for output 2 is dictated by the automatic power and gain settings established for

output 1. Whenever output 1 is taught, output 2 also must be retaught. Applications hint: teach the weakest signal on

output 1 first.

Installation

Install the product on a 35 mm DIN rail or the included mounting bracket.

Plastic Fiber

Emitter Port

Plastic Fiber

Receiver Port

Slides Up to

Release Fibers

Wiring Diagrams

NPN Output Models

3

1

4

5

6

2

12-24V dc

–

+

Load

Teach

Gate

Load

1

2

PNP Output Models

3

1

4

5

6

2

12-24V dc

–

+

Load

Teach

Gate

Load

1

2

Key

1 = Brown

2 = White

3 = Blue

4 = Black

5 = Gray

6 = Pink

Quick disconnect (QD) wiring diagrams are functionally identical.

Configuration Instructions

Active Channel Select

•

Selects which channel to teach

•

Displays channel configuration information.

P/N 64154 Rev. G

www.bannerengineering.com - Tel: +1-763-544-3164

3