MCP39F511N datasheet(49/61 Pages) MICROCHIP

49 / 61 page

 2015-2018 Microchip Technology Inc.

DS20005473B-page 49

MCP39F511N

9.6

Calibrating the Line Frequency

The Line Frequency register contains a 16-bit number

with a value equivalent to the input-line frequency as it

is measured on the voltage channel.

The measurement of the line frequency is only valid

from 45 to 65 Hz.

9.6.1

USING THE AUTO-CALIBRATE

FREQUENCY COMMAND

By applying a stable reference voltage with a constant

line frequency that is equivalent to the value that

resides in the LineFrequencyRef register, the

Auto-Calibrate Frequency

command can then

be issued to the device.

After a successful calibration (response = ACK), a

Save Registers to Flash

command can then be

issued to save the calibration constants calculated by

the device.

The

following

set

when

the

Auto-Calibrate Frequency

command is issued:

• Gain Line Frequency

The formula used to calculate the new gain is shown in

Equation 9-1.

9.7

Retrieving Factory-Default

Calibration Values

After user calibration and a Save to Flash command

has been issued, it is possible to retrieve the

factory-default calibration values. This can be done by

writing 0xA5A5 to the Calibration Delimiter register,

issuing a Save to Flash, and then resetting the part.

This

procedure

will

retrieve

all

factory

default-calibration values and will remain in this state

until calibration has been performed again, and a Save

to Flash

command has been issued.

MCP39F511N Datenblatt(PDF) 49 Page - Microchip Technology

MCP39F511N Datenblatt(HTML) 49 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61

Datenblatt Download

Link URL