MP4680 datasheet(6/28 Pages) PHILIPS

6 / 28 page

1996 Oct 25

Philips Semiconductors

Product speciﬁcation

Video processor with automatic cut-off

and white level control

TDA4680

I2C-BUS

Control

The I2C-bus transmitter/receiver provides the data bytes to

select and adjust the following functions and parameters:

• Brightness adjust

• Saturation adjust

• Contrast adjust

• Hue control voltage

• RGB gain adjust

• RGB reference voltage levels

• Peak drive limiting

• Selection of the vertical blanking interval and

measurement lines for cut-off and white level control

according to transmission standard

• Selects either 3-level or 2-level (5 V) sandcastle pulse

• Enables/disables input clamping pulse delay

• Enables/disables white level control

• Enables cut-off control; enables output clamping

• Enables/disables full screen white level

• Enables/disables full screen black level

• Selects either PAL/SECAM or NTSC matrix

• Enables saturation adjust; enables nominal saturation

• Enables/disables synchronization of the execution of

I2C-bus commands with the vertical blanking interval

• Reads the result of the comparison of the nominal and

actual RGB signal levels for automatic white level

control.

I2C-bustransmitter/receiver and data transfer

I2C-BUS SPECIFICATION

The I2C-bus is a bidirectional, two-wire, serial data bus for

intercommunication between ICs in a system.

The microcontroller transmits/receives data from the

I2C-bus transceiver in the TDA4680 over the serial data

line SDA (pin 27) synchronized by the serial clock line SCL

(pin 28). Both lines are normally connected to a positive

voltage supply through pull-up resistors. Data is

transferred when the SCL line is LOW. When SCL is HIGH

the serial data line SDA must be stable. A HIGH-to-LOW

transition of the SDA line when SCL is HIGH is defined as

a START bit. A LOW-to-HIGH transition of the SDA line

when SCL is HIGH is defined as a STOP bit.

Each transmission must start with a START bit and end

with a STOP bit. The bus is busy after a START bit and is

only free again after a STOP bit has been transmitted.

I2C-BUS RECEIVER (MICROCONTROLLER WRITE MODE)

Each transmission to/from the I2C-bus transceiver

consists of at least three bytes following the START bit.

Each byte is acknowledged by an acknowledge bit

immediately following each byte. The first byte is the

Module Address (MAD) byte, also called slave address

byte. This consists of the module address, 1000100 for the

TDA4680, plus the R/W bit (see Fig.4). When the

TDA4680 is a slave receiver (R/W = 0) the module

address byte is 10001000 (88H). When the TDA4680 is a

slave transmitter (R/W = 1) the module address byte is

10001001 (89H).

The length of a data transmission is unrestricted, but the

module address and the correct sub-address must be

transmitted before the data byte(s). The order of data

transmission is shown in Figs 5 and 6.

Without auto-increment (BREN = 0 or 1) the module

address (MAD) byte is followed by a Sub-Address (SAD)

byte and one data byte only (see Fig.5).

MP4680 Datenblatt(PDF) 6 Page - NXP Semiconductors

MP4680 Datenblatt(HTML) 6 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Datenblatt Download

Link URL