ATtiny25-15ST datasheet(5/196 Pages) ATMEL

5 / 196 page

7598H–AVR–07/09

ATtiny25/45/85

2.3

Pin Descriptions

2.3.1

VCC

Supply voltage.

2.3.2

GND

Ground.

2.3.3

Port B (PB5..PB0)

Port B is a 6-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The

Port B output buffers have symmetrical drive characteristics with both high sink and source

capability. As inputs, Port B pins that are externally pulled low will source current if the pull-up

resistors are activated. The Port B pins are tri-stated when a reset condition becomes active,

even if the clock is not running.

Port B also serves the functions of various special features of the ATtiny25/45/85 as listed on

page 54.

2.3.4

RESET

Reset input. A low level on this pin for longer than the minimum pulse length will generate a

reset, even if the clock is not running. The minimum pulse length is given in Table 8-1 on page

37. Shorter pulses are not guaranteed to generate a reset.

About Code Examples

This documentation contains simple code examples that briefly show how to use various parts of

the device. These code examples assume that the part specific header file is included before

compilation. Be aware that not all C compiler vendors include bit definitions in the header files

and interrupt handling in C is compiler dependent. Please confirm with the C compiler documen-

tation for more details.

AVR CPU Core

4.1

Introduction

This section discusses the AVR core architecture in general. The main function of the CPU core

is to ensure correct program execution. The CPU must therefore be able to access memories,

perform calculations, control peripherals, and handle interrupts.

ATtiny25-15ST Datenblatt(PDF) 5 Page - ATMEL Corporation