| Datenblatt-Suchmaschine für elektronische Bauteile |
|
33480 Datenblatt(PDF) 13 Page - Freescale Semiconductor, Inc |
|
|
|||||||||||||||||||||||||||||
33480 Datenblatt(HTML) 13 Page - Freescale Semiconductor, Inc |
|
13 / 39 page ![]() Analog Integrated Circuit Device Data Freescale Semiconductor 13 33480 DYNAMIC ELECTRICAL CHARACTERISTICS I/O PLAUSIBILITY CHECK TIMING (CONTINUED) High Overcurrent Threshold Time 1 for OUT1 and OUT5 for OUT2:4 tOUT1 tOUT2 7 14 10 20 13 26 ms High Overcurrent Threshold Time 2 for OUT1 and OUT5 for OUT2:4 tOUT1 tOUT2 52.5 105 75 150 97.5 195 ms Autorestart Period for OUT1 and OUT5 for OUT2 tAUTORST-T1 tAUTORST-T2 52.5 105 75 150 97.5 195 ms Autorestart Overcurrent Shutdown Delay Time for OUT1 and OUT5 for OUT2 tOCHIARS tOCHIARS 3.5 7.0 5.0 10.0 6.5 13.0 ms Limp Home Input pin Deglicher Time tLIMP 7.0 10.0 13.0 ms Cyclic Open Load Detection Timing with LED (37) tOLLED 105 150 195 ms Flasher Toggle Timeout tFLASHER 1.4 TBD TBD s Ignition Toggle Timeout tIGNITION 1.4 TBD TBD s Clock Input Low Frequency Detection Range fLCLK det 1.0 2.0 4.0 kHz Clock Input High Frequency Detection Range fHCLK det 100 200 400 kHz Notes 35. The PWM ratio is measured at Vout = 50% of VBAT in nominal range of PWM frequency (from 60Hz to 200Hz). It is possible to put the device fully on (PWM duty cycle = 100%) and fully off (PWM duty cycle = 0%). Between 4%-96%, OCHI1,2, OCLO and open load are available in ON state.See Figure 4, Input Timing Switching Characteristics 36. Linear range is defined by output duty cycle to SPI duty cycle configuration +/-1 LSB. For values outside linear duty cycle range, a calibration curve is available. 37. IOLLEDn bit (where “n” corresponds to respective outputs 1 through 5) in SI data is set to logic [1]. Refer to Table 8, Serial Input Address and Configuration Bit Map, page 28. Table 4. Dynamic Electrical Characteristics Characteristics noted under conditions 4.5 V ≤ VCC ≤ 5.5 V, 7.0 V ≤ VBAT ≤ 18 V, -40°C ≤ TA ≤ 125°C, GND = 0 V unless otherwise noted. Typical values noted reflect the approximate parameter means at TA = 25°C under nominal conditions unless otherwise noted. Characteristic Symbol Min Typ Max Unit |
|
Link URL |
| War ALLDATASHEET hilfreich? [ DONATE ] |
Über Alldatasheet | Werbung | Kontakt | Privatsphäre und Datenschutz | Link zum Datenblatt | Linktausch | Hersteller All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |