W25Q80BWSVIP datasheet(55/74 Pages) WINBOND

55 / 74 page

W25Q80BW

Publication Release Date: July 30, 2013

- 55 -

Revision J

7.2.36

Erase Security Registers (44h)

The W25Q80BW offers four 256-byte Security Registers which can be erased and programmed

individually. These registers may be used by the system manufacturers to store security and other

important information separately from the main memory array.

The Erase Security Register instruction is similar to the Sector Erase instruction. A Write Enable

instruction must be executed before the device will accept the Erase Security Register Instruction (Status

instruction code “44h” followed by a 24-bit address (A23-A0) to erase one of the four security registers.

ADDRESS

A23-16

A15-12

A11-8

A7-0

Security Register #0*

00h

0 0 0 0

Don’t Care

Security Register #1

00h

0 0 0 1

0 0 0 0

Don’t Care

Security Register #2

00h

0 0 1 0

0 0 0 0

Don’t Care

Security Register #3

00h

0 0 1 1

0 0 0 0

Don’t Care

* Please note that Security Register 0 is Reserved by Winbond for future use. It is

recommended to use Security registers 1- 3 before using register 0.

The Erase Security Register instruction sequence is shown in figure 34. The /CS pin must be driven high

after the eighth bit of the last byte has been latched. If this is not done the instruction will not be executed.

After /CS is driven high, the self-timed Erase Security Register operation will commence for a time

duration of tSE (See AC Characteristics). While the Erase Security Register cycle is in progress, the Read

Status Register instruction may still be accessed for checking the status of the BUSY bit. The BUSY bit is

a 1 during the erase cycle and becomes a 0 when the cycle is finished and the device is ready to accept

other instructions again. After the Erase Security Register cycle has finished the Write Enable Latch

(WEL) bit in the Status Register is cleared to 0. The Security Register Lock Bits (LB3-0) in the Status

corresponding security register will be permanently locked, Erase Security Register instruction to that

/CS

CLK

(IO

Mode 0

Mode 3

Instruction (44h)

High Impedance

24-Bit Address

Mode 0

Mode 3

= MSB

Figure 34. Erase Security Registers Instruction Sequence

W25Q80BWSVIP Datenblatt(PDF) 55 Page - Winbond

W25Q80BWSVIP Datenblatt(HTML) 55 Page - Winbond

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74

Datenblatt Download

Link URL