| Datenblatt-Suchmaschine für elektronische Bauteile |
|
SPEAR320S Datenblatt(PDF) 17 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
SPEAR320S Datenblatt(HTML) 17 Page - STMicroelectronics |
|
17 / 113 page ![]() SPEAr320S Device functions Doc ID 022508 Rev 2 17/113 2.9.2 RMII0 and MII1/RMII1 Ethernet controllers These functional blocks extend Ethernet capability by covering the Media independent interface (MII) and Reduced media independent interface (RMII) standards. They can be used in two ways: ● as a single additional MAC controller with Media independent interface (MII1) ● as two MAC controllers with Reduced media independent interface (RMII0, RMII1) In RMII configuration, each controller has an independent set of data and control lines. The reference clock (50 MHz) is shared by the controllers. Main features: ● Compatible with IEEE Standard 802.3 ● UNH tested ● 10 and 100 Mbit/s operation ● Full and half duplex operation ● Statistics counter registers for RMON/MIB ● Automatic pad and CRC generation on transmitted frames ● Automatic discard of frames received with errors ● Address checking logic supports up to four specific 48-bit addresses ● Supports promiscuous mode where all valid received frames are copied to memory ● Hash matching of unicast and multicast destination addresses ● External address matching of received frames ● Supports serial network interface operation ● Half-duplex flow control by forcing collisions on incoming frames ● Full-duplex flow control with recognition of incoming pause frames and hardware generation of transmitted pause frames ● Support for 802.1Q VLAN tagging with recognition of incoming VLAN and priority tagged frames ● Multiple buffers per receive and transmit frame ● Jumbo frames of up to 10240 bytes supported 2.10 MMC-SD card/SDIO controller The MMC-SD card /SDIO controller conforms to the SD Host Controller Standard Specification, version 2.0. It handles SD/SDIO protocol at transmission level by packing data, adding cyclic redundancy check (CRC) and start/end bit as well as checking for transaction format correctness. The controller is designed to work with I/O cards, read-only cards and read/write cards, and can operate either in SD mode (1-bit, 4-bit, 8-bit) or in SPI mode. |
|
Link URL |
| War ALLDATASHEET hilfreich? [ DONATE ] |
Über Alldatasheet | Werbung | Kontakt | Privatsphäre und Datenschutz | Link zum Datenblatt | Linktausch | Hersteller All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |