LTC2445 datasheet(19/28 Pages) LINER

19 / 28 page

LTC2444/LTC2445/

LTC2448/LTC2449

sn2444589 2444589fs

Internal Serial Clock, Single Cycle Operation

This timing mode uses an internal serial clock to shift out

the conversion result and a CS signal to monitor and

control the state of the conversion cycle, see Figure 7.

In order to select the internal serial clock timing mode, the

EXT pin must be tied HIGH.

The serial data output pin (SDO) is Hi-Z as long as CS is

HIGH. At any time during the conversion cycle, CS may be

pulled LOW in order to monitor the state of the converter.

Once CS is pulled LOW, SCK goes LOW and EOC is output

to the SDO pin. EOC = 1 while a conversion is in progress

and EOC = 0 if the device is in the sleep state. Alternatively,

BUSY (Pin 2) may be used to monitor the status of the

conversion in progress. BUSY is HIGH during the conver-

Figure 7. Internal Serial Clock, Single Cycle Operation

MSB

BIT 28 BIT 27 BIT 26 BIT 25 BIT 24 BIT 23 BIT 22 BIT 21

BIT 20 BIT 19

BIT 0

LSB

Hi-Z

2444 F08

SIG

BIT 29

“0”

BIT 30

EOC

Hi-Z

SCK

SDI

SDO

BUSY

BIT 31

SGL

OSR3

OSR2

OSR1

OSR0

TWOX

ODD

12345

CONVERSION

SLEEP

DATA OUTPUT

CONVERSION

TEST EOC

DON'T CARE

<tEOC(TEST)

VCC

REF+

REF–

CH0

CH7

CH8

CH15

COM

SCK

SDI

SDO

GND

1,4,5,6,31,32,33

REFERENCE

VOLTAGE

0.1V TO VCC

ANALOG

INPUTS

= EXTERNAL OSCILLATOR

= INTERNAL OSCILLATOR

1µF

2.7V TO 5.5V

LTC2448

4-WIRE

SPI INTERFACE

•

BUSY

sion and goes LOW at the conclusion. It remains LOW until

the result is read from the device.

When testing EOC, if the conversion is complete (EOC = 0),

the device will exit the sleep state and enter the data output

state if CS remains LOW. In order to prevent the device

from exiting the low power sleep state, CS must be pulled

HIGH before the first rising edge of SCK. In the internal

SCK timing mode, SCK goes HIGH and the device begins

outputting data at time tEOCtest after the falling edge of CS

(if EOC = 0) or tEOCtest after EOC goes LOW (if CS is LOW

during the falling edge of EOC). The value of tEOCtest is

500ns. If CS is pulled HIGH before time tEOCtest, the device

remains in the sleep state. The conversion result is held in

the internal static shift register.

APPLICATIO S I FOR ATIO

LTC2445 Datenblatt(PDF) 19 Page - Linear Technology

LTC2445 Datenblatt(HTML) 19 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Datenblatt Download

Link URL