M500000013 datasheet(13/70 Pages) SPANSION

13 / 70 page

Am50DL9608G

May 19, 2003

P R E L I M I NARY

vice requires standard access time (t

CE) for read ac-

cess when the device is in either of these standby

modes, before it is ready to read data.

If the device is deselected during erasure or program-

ming, the device draws active current until th e

operation is completed.

CC3f in the table represents the standby current speci-

fication.

Automatic Sleep Mode

The automatic sleep mode minimizes Flash device en-

ergy consumption. The device automatically enables

this mode when addresses remain stable for t

ACC +

30 ns. The automatic sleep mode is independent of

the CE#f, WE#, and OE# control signals. Standard ad-

dress access timings provide new data when ad-

dresses are changed. While in sleep mode, output

data is latched and always available to the system.

CC5f in the table represents the automatic sleep mode

current specification.

RESET#: Hardware Reset Pin

The RESET# pin provides a hardware method of re-

setting the device to reading array data. When the RE-

SET# pin is driven low for at least a period of t

RP, the

device immediately terminates any operation in

progress, tristates all output pins, and ignores all

read/write commands for the duration of the RESET#

pulse. The device also resets the internal state ma-

chine to reading array data. The operation that was in-

terrupted should be reinitiated once the device is

ready to accept another command sequence, to en-

sure data integrity.

Current is reduced for the duration of the RESET#

pulse. When RESET# is held at V

SS±0.3 V, the device

draws CMOS standby current (I

CC4f). If RESET# is

held at V

IL but not within VSS±0.3 V, the standby cur-

rent will be greater.

The RESET# pin may be tied to the system reset cir-

cuitry. A system reset would thus also reset the Flash

memory, enabling the system to read the boot-up firm-

ware from the Flash memory.

If RESET# is asserted during a program or erase op-

eration, the RY/BY# pin remains a “0” (busy) until the

internal reset operation is complete, which requires a

time of t

READY (during Embedded Algorithms). The

system can th us monito r RY/BY# to de termin e

whether the reset operation is complete. If RESET# is

asserted when a program or erase operation is not ex-

ecuting (RY/BY# pin is “1”), the reset operation is com-

pleted within a time of t

READY (not during Embedded

Algorithms). The system can read data t

RH after the

RESET# pin returns to V

IH.

Refer to the Flash AC Characteristics tables for RE-

SET# parameters and to Figure 15 for the timing dia-

gram.

Output Disable Mode

When the OE# input is at V

IH, output from the device is

disabled. The output pins are placed in the high

impedance state.

M500000013 Datenblatt(PDF) 13 Page - SPANSION

M500000013 Datenblatt(HTML) 13 Page - SPANSION

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70

Datenblatt Download

Link URL