ST7FLCD1 datasheet(51/95 Pages) STMICROELECTRONICS

Teilenummer	ST7FLCD1

Bauteilbeschribung	8-bit MCU for LCD Monitors with 60 KBytes Flash,2 KBytes RAM, 2 DDC Ports and Infrared Controller

PDF	95 Pages

Scroll/Zoom	100%

Hersteller	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

51 / 95 page

51/95

ST7FLCD1

8-bit Analog-to-Digital Converter (ADC)

CONTROL/STATUS REGISTER (ADCCSR)

Read/Write

Reset Value: (00h)

Bit 7 = COCO Conversion Complete

This bit is set by hardware. It is cleared by software by reading the result in the DR register or

writing to the CSR register.

Conversion is not complete (default)

Conversion can be read from the DR register.

Bit 6 = Reserved. This bit must be cleared by software.

Bit 5 = ADON A/D converter On

This bit is set and cleared by software.

A/D converter is switched off (default)

A/D converter is switched on

Note:

Remember that the ADC needs time to stabilize after the ADON bit is set.

Bits [4:2] = Reserved. Forced to 0 by hardware.

Bits [1:0] = CH[1:0] Channel Selection.

These bits are set and cleared by software. They select the analog input to be converted.

DATA REGISTER (ADCDR)

Read Only

Reset Value: (00h)

Bits [7:0] = AD[7:0] Analog Converted Value.

This register contains the converted analog value in the range 00h to FFh.

Reading this register resets the COCO flag.

765

432

COCO

ADON

CH1

CH0

Table 20: Channel Selection

CH1

CH0

AIN0 (Default)

AIN1

AIN2

AIN3

765

432

AD7

AD6

AD5

AD4

AD3

AD2

AD1

AD0

ST7FLCD1 Datenblatt(PDF) 51 Page - STMicroelectronics

ST7FLCD1 Datenblatt(HTML) 51 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95

Datenblatt Download

Link URL