AT25QL128A datasheet(5/84 Pages) DIALOG

5 / 84 page

AT25QL128A

DS-AT25QL128A–129E–01-2021

1Introduction

The Adesto® AT25QL128A is a serial interface Flash memory device designed for use in a wide variety of high-

volume consumer based applications in which program code is shadowed from Flash memory into embedded or

external RAM for execution. The flexible erase architecture of the AT25QL128A is ideal for data storage as well,

eliminating the need for additional data storage devices.

The erase block sizes of the AT25QL128A have been optimized to meet the needs of today's code and data

storage applications. By optimizing the size of the erase blocks, the memory space can be used much more

efficiently. Because certain code modules and data storage segments must reside by themselves in their own

erase regions, the wasted and unused memory space that occurs with large block erase Flash memory devices

can be greatly reduced. This increased memory space efficiency allows additional code routines and data storage

segments to be added while still maintaining the same overall device density.

SPI clock frequencies of up to 133 MHz are supported, allowing equivalent clock rates of 266 MHz for Dual Output,

and 532 MHz for Quad Output when using the QPI and Fast Read Dual/Quad I/O instructions.The AT25QL128A

array is organized into 65,536 programmable pages of 256-bytes each. Up to 256 bytes can be programmed at a

time using the Page Program instructions. Pages can be erased in block increments of 4 kbytes, 32 kbytes, or

64 kbytes, or the entire chip.

The devices operate on a single 1.7 V to 2.0 V power supply with current consumption as low as 5 mA active and

2 µA for Deep Power Down. All devices offered in space-saving packages. The device supports JEDEC standard

manufacturer and device identification with a 4-kbit secured OTP.

AT25QL128A Datenblatt(PDF) 5 Page - Dialog Semiconductor