AT80SND1C-ROTIL datasheet(76/210 Pages) ATMEL

76 / 210 page

AT8xC51SND1C

4109E–8051–06/03

Table 83. Sample Duplication Factor

MP3 Buffer

In song playing mode, the audio stream comes from the MP3 decoder through a buffer.

The MP3 buffer is used to store the decoded MP3 data and interfaces to the decoder

through a 16-bit data input and data request signal. This signal asks for data when the

buffer has enough space to receive new data. Data request is conditioned by the

DREQEN bit in AUDCON1 register. When set, the buffer requests data to the MP3

decoder. When cleared no more data is requested but data are output until the buffer is

empty. This bit can be used to suspend the audio generation (pause mode).

Interrupt Request

The audio interrupt request can be generated by 2 sources when in C51 audio mode: a

sample request when SREQ flag in AUDSTA register is set to logic 1, and an under-run

condition when UDRN flag in AUDSTA register is set to logic 1. Both sources can be

enabled separately by masking one of them using the MSREQ and MUDRN bits in

AUDCON1 register. A global enable of the audio interface is provided by setting the

EAUD bit in IEN0 register.

The interrupt is requested each time one of the 2 sources is set to one. The source flags

are cleared by writing some data in the audio buffer through AUDDAT, but the global

audio interrupt flag is cleared by hardware when the interrupt service routine is

executed.

Figure 52. Audio Interface Interrupt System

MP3 Song Playing

In MP3 song playing mode, the operations to do are to configure the PLL and the audio

interface according to the DAC selected. The audio clock is programmed to generate

the 256·Fs or 384·Fs as explained in Section "Clock Generator", page 74. Figure 53

shows the configuration flow of the audio interface when in MP3 song mode.

DUP1

DUP0

Factor

No sample duplication, DAC rate = 8 kHz (C51 rate).

One sample duplication, DAC rate = 16 kHz (2 x C51 rate).

2 samples duplication, DAC rate = 32 kHz (4 x C51 rate).

Three samples duplication, DAC rate = 48 kHz (6 x C51 rate).

SREQ

AUDSTA.7

Audio

Interrupt

Request

UDRN

AUDSTA.6

MSREQ

AUDCON1.5

EAUD

IEN0.6

MUDRN

AUDCON1.4

AT80SND1C-ROTIL Datenblatt(PDF) 76 Page - ATMEL Corporation

AT80SND1C-ROTIL Datenblatt(HTML) 76 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datenblatt Download

Link URL