ATmega16 datasheet(86/357 Pages) ATMEL

86 / 357 page

2466S–AVR–05/09

ATmega16(L)

• Bit 0 – TOIE0: Timer/Counter0 Overflow Interrupt Enable

When the TOIE0 bit is written to one, and the I-bit in the Status Register is set (one), the

Timer/Counter0 Overflow interrupt is enabled. The corresponding interrupt is executed if an

overflow in Timer/Counter0 occurs, i.e., when the TOV0 bit is set in the Timer/Counter Interrupt

Flag Register – TIFR.

Timer/Counter

Interrupt Flag Register

– TIFR

• Bit 1 – OCF0: Output Compare Flag 0

The OCF0 bit is set (one) when a compare match occurs between the Timer/Counter0 and the

data in OCR0 – Output Compare Register0. OCF0 is cleared by hardware when executing the

corresponding interrupt handling vector. Alternatively, OCF0 is cleared by writing a logic one to

the flag. When the I-bit in SREG, OCIE0 (Timer/Counter0 Compare Match Interrupt Enable), and

OCF0 are set (one), the Timer/Counter0 Compare Match Interrupt is executed.

• Bit 0 – TOV0: Timer/Counter0 Overflow Flag

The bit TOV0 is set (one) when an overflow occurs in Timer/Counter0. TOV0 is cleared by hard-

ware when executing the corresponding interrupt handling vector. Alternatively, TOV0 is cleared

by writing a logic one to the flag. When the SREG I-bit, TOIE0 (Timer/Counter0 Overflow Inter-

rupt Enable), and TOV0 are set (one), the Timer/Counter0 Overflow interrupt is executed. In

phase correct PWM mode, this bit is set when Timer/Counter0 changes counting direction at

$00.

Bit

765

4321

OCF2

TOV2

ICF1

OCF1A

OCF1B

TOV1

OCF0

TOV0

TIFR

Read/Write

R/W

Initial Value

000

0000

ATmega16 Datenblatt(PDF) 86 Page - ATMEL Corporation