SPEAR300 datasheet(36/83 Pages) STMICROELECTRONICS

36 / 83 page

Pin description

SPEAr300

36/83

Doc ID 16324 Rev 2

The following modes can be selected by programming some control registers present in the

reconfigurable array subsystem.

●

NAND mode

●

NOR Mode

●

PHOTO_FRAME Mode (PHOTO FRAME)

●

LEND_IP_PHONE Mode (LOW END IP PHONE)

●

HEND_IP_PHONEMode (HIGH END IP PHONE)

●

LEND_WIFI_PHONE Mode (LOW END WI-FI PHONE)

●

HEND_WIFI_PHONE Mode (HIGH END WI-FI PHONE)

●

ATA_PABX_wI2S Mode (ATA PABX without I2S)

●

ATA_PABX_I2S Mode (ATA PABX with I2S)

●

CAMl_LCDw Mode (8-bit CAMERA without LCD)

●

CAMu_LCD Mode (14-bit camera with LCD)

●

CAMu_wLCD Mode (14-bit camera without LCD)

●

CAMl_LCD Mode (8-bit camera with LCD)

Configuration 1 is the default mode for SPEAr300. It supports the FSMC interface for NAND

Flash connectivity and boot pins used for selecting the boot mode.

Mode 1: NAND interface

NAND mode mainly provides:

●

NAND Flash interface (16 bits, 5 control signals)

Mode 2: NOR interface

NOR mode mainly provides:

●

External Memory Interface (16 data bits, 24 address bits and 4 chip selects)

Mode 3: Photo frame

Photo frame mode mainly provides:

●

NAND Flash interface (16 bits, 5 control signals)

●

CLCD controller interface

●

TDM for voice/music capabilities

●

SDIO interface supporting SPI, SD1, SD4 and SD8 mode

●

GPIOs with interrupt capability

Mode 4: Low end IP phone

Low end IP phone mode mainly provides:

●

9x9 keyboard

●

8 SPI/I2C control signals

●

I2S block

●

GPIOs with interrupt capability

●

Digital-to-analog converter (DAC)

SPEAR300 Datenblatt(PDF) 36 Page - STMicroelectronics

SPEAR300 Datenblatt(HTML) 36 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83

Datenblatt Download

Link URL