PIC16F570 datasheet(53/129 Pages) MICROCHIP

53 / 129 page

 2013-2014 Microchip Technology Inc.

DS40001684E-page 53

PIC16F570

8.15

Program Verification/Code

Protection

If the code protection bit has not been programmed, the

on-chip program memory can be read out for

verification purposes.

The first 64 locations and the last location (OSCCAL)

can be read, regardless of the code protection bit

setting.

8.16

ID Locations

Four memory locations are designated as ID locations

where the user can store checksum or other code

identification numbers. These locations are not

accessible during normal execution, but are readable

and writable during Program/Verify.

Use only the lower four bits of the ID locations and

always program the upper eight bits as ‘0’s.

8.17

In-Circuit Serial Programming™

The PIC16F570 microcontroller can be serially

programmed while in the end application circuit. This is

simply done with two lines for clock and data, and three

other lines for power, ground and the programming

voltage. This allows customers to manufacture boards

with unprogrammed devices and then program the

microcontroller just before shipping the product. This

also allows the most recent firmware, or a custom

firmware, to be programmed.

The devices are placed into a Program/Verify mode by

holding the ICSPCLK and ICSPDAT pins low while

raising the MCLR (VPP) pin from VIL to VIHH (see

programming specification). ICSPCLK becomes the

programming clock and ICSPDAT becomes the

programming data. Both ICSPCLK and ICSPDAT are

Schmitt Trigger inputs in this mode.

After Reset, a 6-bit command is then supplied to the

device. Depending on the command, 14 bits of program

data are then supplied to or from the device, depending

if the command was a load or a read. For complete

details of serial programming, please refer to the

PIC16F570 Programming Specifications.

A typical In-Circuit Serial Programming connection is

shown in Figure 8-14.

FIGURE 8-14:

TYPICAL IN-CIRCUIT

SERIAL PROGRAMMING

CONNECTION

External

Connector

Signals

To Normal

Connections

To Normal

Connections

VDD

VSS

MCLR/VPP

ICSPCLK

ICSPDAT

+5V

VPP

CLK

Data

VDD

PIC® Device

PIC16F570 Datenblatt(PDF) 53 Page - Microchip Technology

PIC16F570 Datenblatt(HTML) 53 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datenblatt Download

Link URL