8

TEMPERATURE CONTROLLER

SPECIFICATIONS

LD250mTC5

LD2TC5

LD5TC10

UNIT

NOTE

OUTPUT

Current Limit Range

0 to 5

0 to 5

0 to 10

A

Short Term Stability [1,2]

0.0009

°C

Measured over 1 hour

Long Term Stability [1,2]

0.005

°C

Measured over 24 hours

SENSOR COMPATIBILITY

Thermistor Voltage Range

0 to 10

V

Two Wire RTD Range

100 to 1000

Ω

Bias Current Range

0.01 to 10

mA

Auto-ranging

Bias Current Accuracy

0.008

%

Bias Current Temperature Coefficient

25

ppm / ºC

Linear Voltage or Current Sensors

Supported

Comparable to LM335 and AD590

Monitor and Limit On-Screen Resolution

0.001

°C

Current Limit to Actual Output Current Accuracy

2

%

Set to Actual Temperature Monitor Accuracy

0.04

%

Feedback

IntelliTune® PID

GENERAL SPECIFICATIONS

VALUE

UNIT

NOTE

Operating Temperature

0 to 50

°C

Nominal operating temperature is

25°C

Storage Temperature

0 to 50

°C

Maximum Operating Humidity

80

%

Relative humidity at 30°C, non-

condensing

Warm-Up Time

1

hour

Internal Over-Temperature Limit

60-70

°C

Remote Interface

USB

Warranty

One (1) Year

Safety Tested To

IEC 61000-3-2

IEC 61000-3-3

IEC 61000-4-2

IEC 61000-4-3

IEC 61000-4-4

IEC 61000-4-5

IEC 61000-4-6

IEC 61000-4-8

IEC 61010-1

EN61010-2-30

EN61326-1

European Council Directive

2004/108/EC & European Council

Directive 2006/95/EC

Size

3.91 × 8.86 × 17.75

(99.3 × 225.0 × 450.9)

in

(mm)

Weight

9.26

(4.2)

lbs

(kg)

POWER SUPPLY REQUIREMENTS

VALUE

NOTE

AC Power Supply and Line Frequency

100-240 VAC (±10%)

3 A, 50-60 Hz

Fuse for 100-240 V

3.15 A 250 AC Fast Blow

(3.15 AH 250 V 5 × 20 mm)

Replacement fuse:

Littelfuse 02163.15 HXP

Maximum AC Line Power

200 W

[1] This specification assumes a steady-state operation with a tuned system using a 10 kΩ thermistor. Typical Stability achieved by measuring

3 standard deviations (3σ) away from the mean over the specified time period. For more detail, see TN-TC02: How is Temperature Stability

Measured?. Stability typical for a 14 pin butterfly package laser diode with a 10 kΩ thermistor.

[2] When using resistive heaters, stability can only be consistently achieved when setpoint temperatures are 10°C or more above ambient.

Stabilitywillvarywithdifferentloadtypes,thermaldesigns,andsensors.RTDsandlinearvoltageandcurrentsensorsare

much less sensitive than thermistors to temperature change, so stability results will not match these specifications. See

TN-TC01: Optimizing Thermoelectric Temperature Control Systems for maximizing system performance.

ELECTRICAL SPECIFICATIONS CONTINUED