WM8739LEDS datasheet(26/35 Pages) WOLFSON

26 / 35 page

WM8739 / WM8739L

Advanced Information

AI Rev 2.2 September 2001

The device can be powered off by writing to the POWEROFF bit of the Power Down register. In

POWEROFF mode the Control Interface and a small portion of the digital remain active. The

analogue VMID reference is disabled. As in STANDBY mode the crystal oscillator pin can be

independently controlled. Refer to Table 18.

DESCRIPTION

POWEROFF, but with Crystal

Oscillator OSC available

POWEROFF, Crystal

oscillator not-available

Table 18 Power Off Mode

DEVICE RESETTING

The WM8739 contains a power on reset circuit that resets the internal state of the device to a known

condition. The power on reset is applied as DCVDD powers on and released only after the voltage

level of DCVDD crosses a minimum turn off threshold. If DCVDD later falls below a minimum turn on

threshold voltage then the power on reset is re-applied. The threshold voltages and associated

hysteresis are shown in the Electrical Characteristics table.

The user also has the ability to reset the device to a known state under software control as shown in

the table below.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

0001111

Reset Register

8:0

RESET

not reset

Reset Register

Writing 00000000 to register resets

device

Table 19 Software Control of Reset

When using the software reset. In 3-wire mode the reset is applied on the rising edge of CSB and

released on the next rising edge of SCLK. In 2-wire mode the reset is applied for the duration of the

ACK signal (approximately 1 SCLK period, refer to Figure 20).

WM8739LEDS Datenblatt(PDF) 26 Page - Wolfson Microelectronics plc