AT25QL641 datasheet(42/77 Pages) DIALOG

Teilenummer	AT25QL641

Bauteilbeschribung	64-Mbit, 1.7V Minimum SPI Serial Flash Memory with Dual I/O, Quad I/O and QPI Support

PDF	77 Pages

Scroll/Zoom	100%

Hersteller	DIALOG [Dialog Semiconductor]

Direct Link	http://www.dialog-semiconductor.com/

Logo

42 / 77 page

AT25QL641

DS-25QL641–130E–10/2018

Figure 7-40. Release Power Down Instruction (QPI Mode)

Figure 7-41. Release Power Down / Device ID Instruction (SPI Mode)

7.25

Read Manufacturer / Device ID Dual I/O (90h)

The ‘Read Manufacturer/ Device ID Dual I/O’ instruction provides both the JEDEC assigned manufacturer ID and the

specific device ID.

The Read Manufacturer/ Device ID instruction is very similar to the Fast Read Dual I/O instruction. The instruction is

initiated by driving the CS pin low and shifting the instruction code “90h” followed by a 24-bit address (A23-A0) of

000000h. After which, the Manufacturer ID for Adesto (1Fh) and the Device ID (16h) are shifted out on the falling edge of

SCK with most significant bit (MSB) first as shown in Figure 7-42 and Figure 7-43. If the 24-bit address is initially set to

000001h, the Device ID is read first and then followed by the Manufacturer ID. The Manufacturer and Device ID can be

read continuously, alternating from one to the other. The instruction is completed by driving CS high.

AT25QL641 Datenblatt(PDF) 42 Page - Dialog Semiconductor