OPA607 datasheet(33/52 Pages) TI2

33 / 52 page

8.2.3 Multichannel Sensor Interface

High-Z input amplifiers are particularly useful when interfaced with sensors that have relatively high output

impedance. Such multichannel systems usually interface these sensors with the signal chain through a

multiplexer. Figure 8-16 shows one such implementation using an amplifier for the interface with each sensor,

and driving into an ADC through a multiplexer. An alternate circuit, shown in Figure 8-17, can use a single higher

GBWP and fast-settling amplifier at the output of the multiplexer. This architecture gives rise to large signal

transients when switching between channels, where the settling performance of the amplifier and maximum

allowed differential input voltage limits signal chain performance and amplifier reliability, respectively.

MUX

ADC

Figure 8-16. Multichannel Sensor Interface Using Multiple Amplifiers

MUX

ADC

OPA810

Figure 8-17. Multichannel Sensor Interface Using a Single Higher GBWP Amplifier

Figure 8-18 shows the output voltage and input differential voltage when a 8-V step is applied at the noninverting

terminal of the OPA810 configured as a unity-gain buffer of Figure 8-17.

Time (10 ns/div)

-5

-2.5

2.5

7.5

BD_M

VIN

VIN,Diff

Figure 8-18. Large-Signal Transient Response Using the OPA810

Because of the fast input transient, the amplifier is slew-limited and the inputs cease to track each other (a

maximum VIN,Diff of 7 V is shown in Figure 8-18) until the output reaches the final value and the negative

feedback loop is closed. For standard amplifiers with a 0.7-V to 1.5-V maximum VIN,Diff rating, current-limiting

resistors must be used in series with the input pins to protect the device from irreversible damage, which also

limits the device frequency response. The OPA810 has built-in input clamps that allow the application of as much

as 7 V of VIN,Diff, with no external resistors required and no damage to the device or a shift in performance

specifications. Such an input-stage architecture, coupled with the fast settling performance, makes the OPA810

a good fit for multichannel sensor multiplexed systems.

www.ti.com

OPA810

SBOS799E – AUGUST 2019 – REVISED AUGUST 2024

Submit Document Feedback

Product Folder Links: OPA810

OPA607 Datenblatt(PDF) 33 Page - Texas Instruments