DLPA2000 datasheet(36/63 Pages) TI

36 / 63 page

7.3.6 Test Point Support

The DLPC34xx test point output port, TSTPT_(7:0), provides selected system calibration and controller debug

support. These test points are inputs when reset is applied. These test points are outputs when reset is released.

The controller samples the signal state upon the release of system reset and then uses the captured value

to configure the test mode until the next time reset is applied. Because each test point includes an internal

pulldown resistor, external pullups must be used to modify the default test configuration.

The default configuration (b000) corresponds to the TSTPT_(2:0) outputs remaining tri-stated to reduce

switching activity during normal operation. For maximum flexibility, a jumper to external pullup resistors is

recommended for TSTPT_(2:0). The pullup resistors on TSTPT_(2:0) can be used to configure the controller

for a specific mode or option. TI does not recommend adding pullup resistors to TSTPT_(7:3) due to potentially

adverse effects on normal operation. For normal use TSTPT_(7:3) should be left unconnected. The test points

are sampled only during a 0-to-1 transition on the RESETZ input, so changing the configuration after reset is

released does not have any effect until the next time reset asserts and releases. Table 7-7 describes the test

mode selections for one programmable scenario defined by TSTPT_(2:0).

Table 7-7. Test Mode Selection Scenario Defined by TSTPT_(2:0)

TSTPT OUTPUT VALUE(1)

NO SWITCHING ACTIVITY

CLOCK DEBUG OUTPUT

TSTPT_(2:0) = 0b000

TSTPT_(2:0) = 0b010

TSTPT_0

HI-Z

60 MHz

TSTPT_1

HI-Z

30 MHz

TSTPT_2

HI-Z

0.7 to 22.5 MHz

TSTPT_3

HI-Z

HIGH

TSTPT_4

HI-Z

LOW

TSTPT_5

HI-Z

HIGH

TSTPT_6

HI-Z

HIGH

TSTPT_7

HI-Z

7.5 MHz

(1)

These are default output selections. Software can reprogram the selection at any time.

DLPC3420

DLPS232 – OCTOBER 2021

www.ti.com

Submit Document Feedback

Product Folder Links: DLPC3420

DLPA2000 Datenblatt(PDF) 36 Page - Texas Instruments

DLPA2000 Datenblatt(HTML) 36 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63

Datenblatt Download

Link URL