28HS01GTAM03 datasheet(10/138 Pages) INFINEON

Teilenummer	28HS01GTAM03

Bauteilbeschribung	S256Mb/512Mb/1Gb SEMPER??Flash Octal interface, 1.8V/3.0V

PDF	138 Pages

Scroll/Zoom	100%

Hersteller	INFINEON [Infineon Technologies AG]

Direct Link	http://www.infineon.com

Logo

10 / 138 page

Datasheet

10 of 138

002-18216 Rev. *W

2022-01-18

256Mb/512Mb/1Gb SEMPER™ Flash

Octal interface, 1.8V/3.0V

Interface overview

2.2

Signal protocols

2.2.1

SEMPER™ Flash octal and SPI clock modes

The SEMPER™ Flash with Octal interface device can be driven by an embedded microcontroller (bus master) in

either of the following two clocking modes:

• Mode 0 with Clock Polarity LOW at the fall of CS# and staying LOW until it goes HIGH at capture input.

• Mode 3 with Clock Polarity HIGH at the fall of CS# then going LOW to HIGH at capture input.

For these two modes, data is latched into the device on the rising edge of the CK signal in SDR protocol and both

edges of the CK signal in DDR protocol. The output data in SDR protocol is available on the falling edge of the CK

clock signal and the output data in DDR protocol is available on the rising edge of the CK clock signal.

The difference between the two modes is the clock polarity when the bus master is in Standby mode and not

transferring any data.

Figure 3

SPI SDR mode support

Figure 4

Octal SDR mode support

28HS01GTAM03 Datenblatt(PDF) 10 Page - Infineon Technologies AG